SEDA Component parts

Here you will find spare parts, equipment and single components for SEDA radiator tools.

CO-Tester
Order number 10320
For the reliable testing of the cylinder head gasket. Sould combustion gasese be found in the radiator system the reaction liquid will change colour. The SEDA test takes place in a closed system and therefore a reliable CO test is even possible in diesel engines. The CO tester can be connected with an express coupling to a SEDA radiator system tester.

CO-Reaction liquid
Order number 10339
0,25 l special liquid, non poisonous, environmentally friendly

Three way pressure control 5-Star with manometer
Order number 10342
The centre piece of the SEDA 5 Star Tester for the express connection with the SEDA plug, thermometer, CO tester and tire inflator.

Pressure control Multitester with manometer
Order number 10332
Robust pressure control with manometer and connections for SEDA plug, CO Tester and tire inflator.

Tire inflator
Order number 10500
To pressurize the radiator system via the SEDA pressure control, but also to inflate tires with air pressure.

Hand pump with manometer 1/8” coupling and 1/8” coupling nipple
Order number 10352
To pressurize the radiator system. Solid design.

3 way distributor for hand pump
Order number 10343
To retrofit the SEDA Praktiker case to the three-in-one test. This will make it possible to test temperature, pressure and CO at the same time with the SEDA hand pump radiator test device.

Hose nipple
Order number 10390
Adaptor with internal thread and O-ring to connect a 6 mm air hose to the SEDA plug.

Coupling nipple
Coupling nipple 1/8" Order number 10370
Coupling nipple 1/4" Order number 10380
To screw on the stopper so that a express coupling can be connected.

Thermometer with thermometer nut
9 ½” / 240mm Order number 13601
10 7/8” / 275mm Order number 13602
To check the operating temperature of the van switch and the thermostat with a union nut and O-ring.

Safety clamp
Order number 10400
This is used when the SEDA plug is shorter than the opening connection piece of the radiator system to be tested.

Wheel nut
Order number 10310
To fit the safety clamp to the SEDA plug

Elbow
Elbow 60° Order number 10510
Elbow 90° Order number 10520
Where there is little space between the radiator opening and the engine hood and/or radiator opening and driver cabin.

Cap nut 2 pieces
Order number 10360
Sealing cap with O-ring for the secure closure of the SEDA plug during the radiator leak test.

Plug holder
Order number 10105
Wall brackets for 5 SEDA plugs.